Aadarsh — Electrical Engineer

Sept 2015-May Home Automation using Brain Wave Sensor and IoT application using Raspberry PI 2016 - To control the electrical load of a particular place using Brain Computer interface and Internet of Things (IoT)

2016 - Designed a Flow Meter with the help of a flow sensor and a water pump. - The number of pulses through the flow meter were generated and they were calibrated for future use. - The designing of the flow meter was done using PLC Relay Ladder Logic Format. Designing of a Baggage Handling System using IP3416 Programmable Logic Controller Dec

Peer to peer communication system, supporting a Carrier Sense Multiple Access (CSMA) protocol" Oct 2017-Dec 2017 - A node is interfaced with a PC, to give user commands to have subsequent transmission on 2-wire RS-485 bus to end in other nodes. - The transceiver will also send unsolicited messages back to the controller in response to changes in input device status

Observed the working and maintenance of various sections such as traction motor section and the battery and UPS section. Involved in the daily maintenance of auxiliary motor section and logged the analyzed technical parameters. Examined the operational difference between Motor Coach and Traction coach and studied the operation of Pantograph.

Worked in a GMP environment which involves manufacturing automotive components. Analysed the distribution of power supply as well as the various safety requirements used for the same. Documented the calibrations of diesel generator into log sheets and studies its variation. Analysed the working and maintenance of 2 different circuit breakers such as Vacuum Circuit Breaker and Air Circuit Breaker. Involved in cyclic maintenance of 3 automotive instruments, lubricating oil and cooling oil system, Inlet and Exhaust valve of a cylinder head.

Studied basics of embedded system and their uses in modern world. Successfully completed projects on "Keypad and 7 segment interfacing" and "Automatic Door Locking System".