Fernando — Robot Programming Specialist

Path Programmer April 2014 – December 2021 (Robots Fanuc P250ib) Commissioning of: 2 Fanuc Robots Co2 application 2 Fanuc Robots Flame application 2 Fanuc Robots for Primer application (application by pneumatic gun) 6 Fanuc Robots Base coat application (4 bell robots with HV unit, 2 application by pneumatic gun) 4 Fanuc Robots Clear coat application (bell robots with HV unit) - Programming trajectories for Project VW NBNF, setting application parameters, Robot Fanuc 250ib. -Programming trajectories for Project VW Golf, setting application parameters, Robot Fanuc 250ib. -Programming trajectories for Project VW Tiguan, T-Rline and Tiguan PA, setting application parameters, Robot Fanuc 250ib. -Programming trajectories for Project VW Jetta A7, setting application parameters, Robot Fanuc 250ib. -Programming trajectories for Project VW Spare Parts, setting application parameters, Robot Fanuc 250ib. -Project acceleration from 30 parts per hour to 50 parts per hour. New application programs were created inside application booths and in Robo guide, reducing cycle times and consumption. Commissioing Cell adhesive Nordson 2K VW Jetta A7 Robot KUKA KR 22 R1610 Validation and adjustment of points. Support for startup Validation handshake signal robot to PLC. Validation safety devices. Check Collision Zone VW Golf A7 Jun 2013 – Mar 2014 (FFT, Puebla, MX. Robots Fanuc) Commissioning of Right Door Line, Left Door line, Lift Gate Line First Set up of robots FANUC Improve path for robots MH, SPOT and SEALING Make Paths and logic for Auto Cap Change