Robot Programmer — Closed

Robot Programmer contract in Elk City, Oklahoma, paying $80/hr.

Automate America is where skilled professionals find work and companies hire them.

CLOSED

Job Description

We are in need of programming support for a Fanuc welding cell with a tool change to a plasma torch.

It would be a plus if the programmer has WeldPro experience. WeldPro is already loaded on the customer computer. The main goal is for the customer to be able to generate programs to cut and bevel holes with the robot with the plasma gun. This cell has been in place for 8 years mainly cutting the same part. Now it is time for a new 30” diameter part to be programmed.

Once the standoffs are manually tacked in place then the robot will automatically change tools. So, the programmer needs to write programs to search the standoffs for proper locations and write programs to weld multi-pass welds.

The programmer will need experience writing programs using search routines, TAST routines, multi-pass routines, user frames and similar programming technique.

This job will begin ASAP and continue for 1 week, 8 hours per day then discussion will take place concerning 1 additional week. Each week will consist of at least 4 days on the customer’s floor with travel in addition to that.

Laptop may be required. No other tools necessary.

Three (3) days Programming Services and plus the associated travel to engage programmer at Customer facility, Elk City, OK as follows:

Day 1: Travel day

Days 2, 3, 4: Onsite work

Day 5: Travel day

Per Diem$50.00
Hotel$120.00
Rental Car$60.00
Mileage$0.58
Airfare$600.00
Travel Time$40.00/hr

Eligibility Questions answered when you apply

  1. Can you pass a drug test?Required30 Days
  2. Can you pass a background check?Required30 Days
  3. Are you authorized to work in the United States?RequiredUS citizens and permanent residents only
  4. Are you profiecient with Fanuc Robots?
  5. Do you have the Fanuc RoboGuide Software?
What is your experience level with Fanuc Robots?
What is your experience level with RoboGuide and WeldPro?
R-30iA, R-30iB, ROBOGUIDE, Fanuc WeldProGood-to-haveLooking for a strong Fanuc Programmer that is profiecient with Roboguide along with the WeldPro Application.
Fanuc Roboguide
ComputerBasic Electrical ToolsBasic Hand ToolsLockout Tagout Kit
Approved timesheets and expenses must be send to each Sunday night. Timesheets must be signed by the customer representative before submission. Expense reports must be signed by the customer representative and include receipts.

The work, as it was posted

Robot Programmer in Elk City, OK.

Posted October 18, 2018, with an estimated end of December 31, 2018, about 2 months of work.

This contract is closed.

Skills and requirements as posted: Fanuc, Basic Electrical Tools, Basic Hand Tools, Computer, Lockout Tagout Kit.

Posted rate: $80/hr.

6 open Robot Programmer contracts are posted now. See open Robot Programmer work.

This contract is closed

Posted October 18, 2018 · Est. end December 31, 2018

Open work like this

All open Robot Programmer work

Related professionals

  • JeremyRobot Programmer · Oklahoma City, OK
  • KristinRobot Programmer · Lawton, Oklahoma
  • ChristopherRobot Programmer · Greer, South Carolina
  • SteveRobot Programmer · St. Clair Shores, MI
  • BradleyRobot Programmer · Clarkston, Michigan
  • StevenRobot Programmer · Taylors, South Carolina
  • WilliamRobot Programmer · LaSalle, Ontario
  • NaxielyRobot Programmer · LaSalle, Ontario