PLC Programmer

CLOSED

Job Description

Programming for retro-fit on a Steering Module line.

Starting off with 2 Programmers expending to 4-5 Engineers in a few weeks.

Additional support TBD for install for 4-5 weeks in November.

PLC – Siemens Step 7 Distributed Safety v. 5.5, SP3

S7-Technology v. 4.2 (for Simotion commands)

HMI – WinCC Flexible 2008 Advanced v. 1.3

Siemens Sinamics servo drives – programmed inside Step 7 PLC software

This project is a retrofit for a steering unit. It will begin in South Carolina and land in Kentucky.

Expenses for travel apply during install in November only.

Per Diem$50.00
Hotel$120.00
Rental Car$60.00
Airfare$600.00
Travel Time$40.50/hr

Requirements that applicants must meet to be eligible

Yes = Able to Apply, No = Not Able to Apply

US work authorizationRequired

Eligibility Questions answered when you apply

  1. 1Are you authorized to work in the United States?Yes
  2. 2Do you have Siemens S7 experience?Yes
  3. 3Do you have WinCC Flexible experience? Yes
S7, Distributed Safety v. 5.5, SP3, S7-Technology v.4.2 (for Simotion commands), Siemens Sinamics servo drives - programmed inside Step 7 PLC software, WinCC Flexible 2008 Advanced v. 1.3Good-to-have
Siemens S7 Distributed Safety v. 5.5 SP3WinCC Flexable 2008 Advanced v. 1.3Siemens S7 v. 4.2Siemens Sinamics Servo Drives
Basic Electrical ToolsBasic Hand ToolsComputerLockout Tagout Kit

Timesheets must be approved and submitted to Diverse Automation Sunday of each week.

Expenses for travel apply during install in November only.

Browse Open Contracts