Christopher — Robotics Engineer

Programmed palatizing picks and drops for multiple framing lines (roof bows, and class A roof) on the 2019 Silverado/Sierra project Programmed BMW X5, X6, and X7 finished door drops

Part of a maintnece team building doors for BMW

Spent time training many Perfect Fit employees (on site training) Went to Graduated school for Higher education

Spent time changing out wire barrels and wire liners for welding

Completed inhouse Engineering projects for Seat testing cells. Work with Controls Engineer to revise current programs to get automated system operational. Also supported production on seat assembly lines.

Union, SC – BWM X5, X6, & X7 doors Programmed palletizing robots for G07 Front/Rear and G05 right hand rear door Maintenance support during regular production Scansonic and Kuka Wire Tec certified laser training Filled in as Maintenance Supervisor

Jackson, MI/ Nexteer – Saginaw, MI Commissioned Fanuc robots Completed all the set up Programmed 1 robot and copied everything into the other with only minor touch ups needed.

Fort Wayne, IN – 2019 Chevrolet Silverado Programmed robots on the framing and box lines Cleaned up weld expulsion and worked with the Weld engineering team to correct spot weld placement Checked and corrected all DCS issues on all robots for framing and box line directly with GM Worked with Mechanical supervisor on multiple issues Programed power and free for body sides and box sides Commissioned and programed sealer robots

Toledo, OH – 2018 Jeep Wrangler Commissioned robots on under body re-spot and programed zones for the entire line Verified and corrected all simulation programs Ran auto payload and calculated Mass, Center of Gravity, and inertia for URS and ARS

Rockford, IL – 2018 Jeep Cherokee Worked on URS, ARS, and UBF programming Worked on step up for URS (minimal) and taught 40% of the URS line (ABB robots) Worked on UBF line doing set up, Programming, backups and housekeeping (inverted Fanuc robots) Programmed Sealer, Spot welding, and Material Handler robots for this job

Honda Marysville, OH– 2017 CRV Independently accountable for the set up and support of the side inner/inner frame 54 robot cell at the MAP facility and worked directly for Honda EGA (Yaskawa robots) Was available at all times for anything that was needed and took care of all errors and faults that occurred Set up and programmed Seal and Material Handler robots

Paslin – Ford F250-550 Underbody sub-assemblies and Mainline Framing all MiG welding Routed all EBC cable management for the entire build shop (over 100 weld robots), this included but was not limited to insuring all cables from snagging or getting caught on conveyors, other robots, or anything else that would cause issues. Calibrated Meta Vision on weld robots Programmed weld paths, reprogrammed/touched up paths, mounted reamers and programmed their paths, added and deleted 100's of lines of code, did weekly backups, programmed and reprogrammed home positions, etc.