Holland, Michigan, United States
Faro Arm, Faro Scanner, Polyworks
We need a Metrologist that specializes with Faro ARM, Faro Scanners, and Polyworks to come in and measure engine rail extrusions.
Using Polyworks, we need the contractor to set up a guided project that an unskilled operator could use and get professional inspection results.
Must be able to interpret GD&T report using Polyworks.
Do they need their own equipment/Software?: We would prefer they provide arm/Polyworks. HOWEVER, if that is a deal breaker, we do have an arm at our facility that we could likely used.
Familiar with and able to interpret GD&T Reports?: Yes, we would be looking for someone that can measure part and correlate back to welding fixture and on-site Final fixture to help trouble shoot dialing fixtures.
Should the contractor expect to be given dimensions and in return, be able to create their own program? Ideally, yes. We do have some programs available, but this was developed by someone in competition with the contract expert and thus I would not expect/request they share that information with a direct competitor.
Software Licenses (Mandatory / Good to Have)
- Good to have
Tools, Machines And Equipment Competencies
- Good to Have
- Start date 02/19/2019
- Estimated end date03/20/2019
- # People needed 1
- Shift Days
- Planned hours per day12
- Planned days per week 4
- Base Rate (per hour) $ 120.00
- OT Rate (per hour) $ 156.00
- DT Rate (per hour) $ 192.00
- Travel Time Rate $ 32.00
- Travel Trips Allowed (per month)-
- Travel Hours Per Round Trip -
Daily Per Diem
(Receipts Not Required)
- Travel Day Per Diem $ 50.00
Hotel Allowance Per Day
Rental Car Allowance
- Mileage Reimbursement Rate Per Mile $ 0.570